Nissan 90 ~93 free download

File name clutch.pdf

CLUTCH 1993 Nissan Sentra 1993 CLUTCH Mechanical Nissan: NX, Sentra DESCRIPTION Clutch assembly is a single disc type with a diaphragm spring pressure plate. Use a mechanical control system consisting of clutch cable, release lever and release bearing. Fig. 1: Exploded View Of Typical Hydraulic Clutch System Courtesy Of Nissan Motor Co., U.S.A. ADJUSTMENTS NOTE: Adjust clutch pedal height before adjusting free play. CLUTCH INTERLOCK SWITCH Clutch interlock switch is located on clutch pedal bracket. With clutch pedal fully depressed, adjust clearance between rubber stopper and threaded end of interlock switch. Clearance should be . 004-.039" (0.10-1.00 mm). CLUTCH PEDAL HEIGHT Clutch pedal height is adjusted by adjusting clutch pedal stopper or clutch switch, located below pedal hinge. See Fig. 2. Loosen lock nut. Rotate clutch pedal stopper or clutch switch until pedal height is as specified in CLUTCH PEDAL HEIGHT SPECIFICATIONS table. Tighten lock nut. CLUTCH PEDAL HEIGHT SPECIFICATIONS TABLE Application NX & Sentra Mechanical Clutch (NX & Sentra) 1) Adjust free play at release lever end of clutch cable. See Fig. 2. Loosen lock nut. Apply hand pressure to release lever in direction of clutch disengagement to remove free play. Tighten adjusting nut. 2) Back off adjusting nut 2.5-3.5 turns. Free play at release lever clevis pin should be .10-.14" (2.5-3.5 mm). Free play at clutch pedal pad should be .43-.59" (10.9-15.0 mm). Fig. 2: Adjusting Clutch Pedal (Mechanical Clutch Shown; Typical) Courtesy of Nissan Motor Co., U.S.A. ЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎ ... In. (mm) 5.91-6.30 (150-160) ЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎЎ CLUTCH PEDAL FREE PLAY REMOVAL & INSTALLATION CAUTION: When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. CLUTCH ASSEMBLY Removal 1) Remove battery and battery holder plate. Remove air cleaner and airflow meter. Disconnect clutch cable or remove clutch slave cylinder. Disconnect speedometer cable and electrical connectors. 2) Remove starter. Disconnect shift control rod, and shift support rod from transaxle. Drain transaxle gear oil. Remove front wheels. On NX and Sentra, remove front exhaust tube. On all models, remove drive axles. See the AXLE SHAFTS - FRONT article in the DRIVE AXLES section. 3) Support rear of engine using jack. Remove left and rear engine mounts. Support transaxle using jack. Remove transaxle-toengine bolts. Remove transaxle. Loosen pressure plate bolts in crisscross pattern. Remove disc and pressure plate. NOTE: All components except clutch disc and release bea